All I had up until yesterday was my tail had the integrated turn signals and it worked fine, got led flush mounts yesterday but there a two wire not a 3 like the stock wiring, found a wiring diagram and hooked them up, if I turned the left side on it would just stay on solid and not flash same with the right side
hi chaps, hope you are all well
i have bought a USB charger in order to keep phone/satnav on charge while on long trips,
the type i bought has a faint LED glow, even when nothing is plugged in, so wiring direct to battery (which is suggests) will put a slow drain on the battery
I changed my oil. Added little in the liter and 3qrts. Glass was full. Turned the bike on and belt bed I always check and it’s low. I have both stands up on the bike and it reads this. Haven’t even rode the bike. Don’t see any leaks while I was on and after. Any help?