Honda CBR 600RR Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I am adjusting my valves at 41k miles. I originally checked them a few days ago and found the exhaust clearances to be just under tolerance and the intakes to be just at minimum tolerance. I am new to feeler gauges and and was essentially doing a "go no go" measurement. I watched some videos on using feeler gauges and the one comment that made the most sense was it should feel (the amount of drag) like pulling tape off of a scotch tape roll. I rechecked them all using my updated technique and came up new numbers. I wanted to see if my numbers generally make sense. I am planning on going down 0.15mm on my exhaust and down 0.10mm on my intake shims.

Thanks!
 
1 - 1 of 1 Posts
Top