Honda CBR 600RR Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,413 Posts
Discussion Starter #1
I am taking my clutch case cover off to redo the gasket. As I pull the cover off, a washer falls out. It's the one that is kinda wavy...it has 3 peaks and is really thin. Is this a spacer? Where does it go?

Moeman, you've been helpful to me in the past, how about again? LOL

edit: this is on a 2006
 

·
Registered
Joined
·
1,413 Posts
Discussion Starter #2
I think I know where it goes...I just looked at a parts catalog online...

There are two small gears that sit right next to each other on the top right of the case as I'm looking at it.

I think it goes under the washer on the Right gear shaft?
 

·
Registered
Joined
·
3,672 Posts
there are how tos here to remove and reinstall clutch cover.
it shows you the wave washer and where it goes.
 

·
Registered
Joined
·
167 Posts
this same thing happened on my 07. by any chance would this thing missing cause the bike to crank but not turn over?

edit: pretty sure my ckp's on upside down
 
1 - 6 of 6 Posts
Top