Honda CBR 600RR Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
392 Posts
Discussion Starter #1
My bike is an 05 600rr with HID's and no HID relay/delay. Everything was fine until yesterday when my low beams wouldn't turn on when the bike was on. My high beam still turned on fine at this point. I then did this write up (http://www.600rr.net/vb/showthread.php?t=138034) to fix my low beam not turning on issue. After I soldered the red and black wire and turned the key to the "ON" position my high beam light is on but low beam isn't. I switched ballasts to have my low beam on when the key is on the "ON" position. Now the problem is my high beam won't turn on. I checked the high beam assembly switch for anything loose and everything is tight and in place. Any suggestions?
 

·
Registered
Joined
·
836 Posts
idk....fuses?
 

·
Registered
Joined
·
8,768 Posts
so you switched ballasts, and the issue followed the balast?

id say bad wire job to the balast, or bad ballast?
 
1 - 5 of 5 Posts
Top