Honda CBR 600RR Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
I'm installing hotbodies LED turn signals in the front. I followed the guide stickied on the top of this page. I"m using a 10W 10 ohm resister in parallel on both sides. When I plug it in, I"m not getting any signals and it's not showing my blinker blinking on the control panel.
 

·
"Superman dat hoe"
Joined
·
1,702 Posts
you need resistors.
 

·
Registered
Joined
·
35 Posts
Discussion Starter #3
I"m using a 10W 10 ohm resister in parallel on both sides
 

·
Premium Member
Joined
·
14,330 Posts
Do you have them wired right???? Green is the ground on your bike....
 

·
Registered
Joined
·
35 Posts
Discussion Starter #6
They are wired correctly. I'll post pick. The instrument panels is working, but when the turn signals are on, they don't light up on the instrument panel.
 

·
Registered
Joined
·
35 Posts
Discussion Starter #9
I haven't tested the wires. I soldered all my connections except I did use the plastic no-solder connector to add in the parallel resistor. I uploaded a diagram showing how I wired it. The pink boxes are the resistors, the blue are the solderless concector. my green wires is hooked up to black on both sides, and I'm connecting the red to the solid orange or blue depending on the side. I'm doing nothing with the striped wire. Please check to make sure I have it right.
 

Attachments

·
Registered
Joined
·
35 Posts
Discussion Starter #10
found out. blown fuse.
 
1 - 10 of 10 Posts
Top