Honda CBR 600RR Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 · (Edited)
ok just mounted my sliders on bike! having problem with the large puck on the right side doesnt fit on only the small puck will! ( as for right side i mean throttle side )


help do i need to modify the larger puck base or am i missing something!

ps will post pics in a few the cuts turned out great!

also gonna post some upgrades homemade did them tonight, and is anyone using this lock?
 

·
Registered
Joined
·
61 Posts
Discussion Starter · #7 ·
I used a 2" hole saw just eyed it up drilled a pilot hole to make sure and then went thru with the hole saw, after that i used a razor blade to cut off excess plastic, finaly i used 220 grit sand paper to finish it off.
 

·
Registered
Joined
·
129 Posts
This is an older thread, but did you get this figured out? Im about to install mine and when looking at the box, there was a sticker that says "install the larger bolt on the left side". One bolt for the slider is about 1/4" - 1/2" longer than the other. Im sure that may be your problem.
 
1 - 8 of 8 Posts
Top