I was looking to buy a mount, but the prices were out of this world for a piece of plastic...
And the one that mounts behind the visor was entirely useless, since my visor is dark smoke.
Here's what I came up with, total cost $1.27 CDN :)
What you need:
- A Dremel
- 4 washers (I used stainless steel)
- One M6 10mm head bolt
- 2 thick washers (I used some that came with my bolt kit) so that the bolt can be tightened, thus locking the GoPro mount in place.
Start by taking off your left mirror.
Then you'll need to use your Dremel and shave off a slim piece of the GoPro mount, as shown in the photos, this will allow it to fit flush against the mirror.
Once that's done, put one washer under the mount, 2 in the middle and 1 above it. Followed by 1 thick washer, 1 thin and 1 thick again.
Insert the 10mm head M6 bolt and lock everything in place.
The reason I chose the mirror mount is because it is a solid front piece on the bike, therefore less vibrations.
For better quality images, please check this link: https://plus.google.com/collection/kw1tMB