Join Date: Jul 2008
Thanked 1 Time in 1 Post
Feedback Score: 0 reviews
Doing this is very easy, basically take the front headlight/ Fairings apart, remove the headlights. Use a hair dryer or heat gun to seperate the lenses. Once that is done, you insert the LED strips into the headlight, use a Clear silicone high temp adhesive. Takes a while to dry but holds well and looks clean. The wiring is somewhat more difficult. Im not great with elctrical but I printed a picture of the wiring diagram from my online manual and had my older brother assist in wiring the way I wanted it. Im sure Tripage would assist in explaining how to do the wiring. I have mine setup so that I can run the bike with the headlights off completely. Leds on by them selves, or both leds and lights. I still have the ability to use the factory hi/low switch on the bars, so I think that the switch I installed essentially just cuts power to the factory switch, so positive/negative and ground off the fuse box. And the second switch is positive/ negative and ground from the battery straight off the battery. The led strips have in line resistors so no additional resistors were needed. I am not very mechanically inclined, but I am sure anyone who takes there time and pays attention to how the fairings come off and the headlights come out will have no problems whatsoever.
Arrow headers and PC III.Puig Double Bubble smoked Windscreen, Two Brothers Carbon Slipon, Competition Werkes Fender Eliminator, Hotbodies flush mounts, CRG Levers,carbon hugger , chain guard, heat shield, and heel guards. Bmc race filter,Targa seat cowl, Pilot power 2ct's, Shogun sliders, Apexcone HID`s, Tripage Hid Delay.Audi led mod.