So just over a week ago I dumped my bike on a ride with some friends going through the country side getting sideways on some turns.
Long story short I shot out of the turn going 80mph into the corner, not enough a** over the bike, and a huge under steer on my part left me in a ditch and my bike hit a pole about 20 yards from where I went off the road.
My frame is A-Okay, engines fine, whole front end is gone ie; plastics, headlights, ram duct air-in, right clip-on, start/ kill imploded - BUT NOW MY BIKE WON'T START.
Post crash my bike got mud under the seat. I removed everything from under the seat and cleaned it out using rubbing alcohol to remove any dirt or possible corrosion. Cleaned as best I could with a toothbrush, q-tips, and some isopropyl rubbing alcohol.
I went back to the accident and located my bank angle sensor (or tip-over sensor) - placed it back in the connector and did my best to balance it as best I could in reference to the stock headlight mount and "UP" arrows.
But the bike still won't start.
It turns over just fine.
I will post photos.
The killswitch is still attached but the only identifiable working element on it is the starter button. I have since purchased a new right clip on with a fully functional start/ kill switch and it was just shipped to me, should be in any day now.
Please help - I am eager to ride and the mother nature is just starting to brighten the days up here in the Pacific Northwest.
Any help would be greatly appreciated.