I bought this bike a few months ago and the pump wouldn’t prime, i was able to us a wire at the relay to get it to run but the headlights and dash went out one night after i had parked it and Ive tried looking everywhere for something that could help, the whole left side control’s seemed to have stopped working to include the horn, i have 12v going to and from my kill switch but i only have around 3 volts at my fuses for my lights, has anyone had this problem before? Im close to cutting up my whole harness and rewiring it or buying a new harness
Itishooliganmills
Joined
·
16,632 Posts
Why would you do something so drastic?
Have you taken the plastics off so you can inspect the PIN connectors and the wiring harness?
Have you checked your resting battery voltage with a multimeter? Had the battery load tested? Cleaned the battery terminals and the main ground bolted to the frame (L) side?
Joined
·
16,632 Posts
Doubtful. Have you tried restoring the wiring harness by removing all of the aftermarket wiring? Buying a used harness is a gamble in itself. You may get a better one. Or you may get a worse one. There's no way to know until you check each wire. So you might as well do that to the wiring harness you have.
Do you have a service manual or wiring diagram?
Dannoxyz has a great troubleshooting writeup that can help you find the problem.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
